The positioning, installation and adjustment of the wire saw machine on the work site includes the installation of the guide rail, the sawing machine and the guide wheel, the threading of the wire rope, wire saw, wire saw flywheel and guide wheel with the same degree of adjustment and other content. According to the position of the cutting surface, the installation of the wire saw machine is divided into the installation of the horizontal plane, the vertical plane and the inclined plane. Vertical sawing is the basic cutting method of wire saw machine, and it is also the most commonly used sawing method in stone mines. In addition to cutting the vertical surface of the separated body, the wire saw machine adopts a vertical cutting method for the disintegration of the separated body and the trimming and cutting of the block. The installation and adjustment of the guide rail of the wire saw machine when cutting the vertical plane can not be ignored. The adjustment of the guide rail is divided into two parts: the adjustment of parallelism with the ruler and the adjustment of its flatness. Visually observe the overlap between the ruler part protruding from the edge of the step and the side of the guide rail, and adjust the guide rail repeatedly until the two overlap is correct, and then simply fix the guide rail. Use a level to measure the horizontal and vertical level of the guide rail. The level of the guide rail can be adjusted by the wedge between the guide rail and the sleeper. If the bottom surface under the guide rail is flat and there is no sleeper between the two, the levelness of the guide rail can be adjusted with electric stones or stones. The adjustment of the level of the guide rail and the adjustment of the degree of coincidence with the ruler can be crossed to prevent one adjustment from affecting the accuracy of another adjustment. The guide rail can be fixed after all adjustment is completed, and the coincidence degree of guide rail and ruler and its levelness have reached the requirements.
