Before installing the wire saw, confirm the direction of the wire saw, and make sure that the arrow direction on the wire saw is consistent with the cutting direction. Some used ropes cannot see the direction of the arrow on the rubber. You can identify the direction of the wire saw based on the direction of the diamond particles on the bead.
Insert the wire saw through the drilled hole on the surface to be cut. Note: When cutting the vertical surface, the moving and running direction of the wire saw must be along the horizontal hole to enter and pass through the vertical hole. When cutting the horizontal plane, determine the penetration direction according to the actual position. The running direction of the wire saw should always be the same from new to old. If you wear it backwards and use it, the whole wire saw will have the possibility of reimbursement.
