The wire saw is a large-scale machine, so there is a certain degree of difficulty in maintenance and maintenance. Only by understanding the routine and regular maintenance procedures can we guarantee better results.
All materials disassembled after the wire saw cutting should be cleaned up in time, sorted and stacked in designated places, and the superstructure should be dumped in tandem, and should not be thrown from a high place at will, and be cleared and transported in time. The dismantled materials and construction waste should be cleaned up in time, and it is strictly forbidden to throw them down at high altitude. The disassembled materials should be placed in a vertical lifting device or an exile trough for removal. The construction waste should be unloaded by setting up a waste well. The demolition construction should be carried out in sections, and no vertical cross operation is allowed.
The hole should be closed. It is strictly forbidden for many people to gather or stack materials on the floor. When removing the beam, it should be ensured that when its fall is effectively controlled, the steel bars at both ends can be cut off, and the steel bars at both ends can be lowered slowly. When removing the column, pick out the steel bars along the bottom of the column, use manual inverted chain directional traction, use gas welding to cut the three-sided steel bars, and keep the steel bars on the front side of the traction direction. When removing pipes and containers, the types and chemical properties of their residues must be ascertained, and corresponding measures can be taken before the removal construction can be carried out.
1. The operation box or switch must be intact and protected by grounding.
2. After the wire saw is used, the power supply should be cut off, cleaned up and placed in place.
3. After replacing the cutting blade, test run to see if there is obvious vibration, and use it after confirming the normal operation.
4. The lever shaft should be intact, flexible and reliable in rotation, and locked with a nut after the lever is assembled.
5. When the wire saw is used, the rotation direction should be avoided as far as possible from the nearby staff, and the cut material should not extend into the sidewalk.
