Home > Knowledge > Content

Performance of Diamond Saw Blade Matrix

May 18, 2022

QQ20220518143105


The matrix is the main body of the diamond saw blade to support the segment, and it is also a rigid part connected to the equipment to realize cutting. The saw blade rotates at high speed to cut the stone, usually at a linear speed of 25-40 meters per second for cutting granite. The line speed for cutting marble is 45-60 meters per second. The matrix with a certain vibration frequency will generate resonance when the additional frequency is consistent with the natural frequency, which requires the matrix to have a high elastic limit and yield ratio. Secondly, due to the unevenness of the body or the poor installation of the saw blade, the lateral pressure generated during cutting causes the substrate to bend repeatedly, resulting in a reduction in the stiffness of the substrate or fatigue strength. Therefore, the matrix should also have high stiffness and fatigue strength. Furthermore, during the cutting process of the saw blade, the substrate is subjected to cyclic cutting pressure and transmission and impact force. Therefore, the matrix should also have high tensile strength and certain impact toughness. The chemical composition and heat treatment state of steel determine the mechanical properties and service life of the product. For products that require high mechanical properties such as saw blade substrates, carbon steel or alloy steel with higher carbon content is usually used. And quenched and tempered at medium temperature to ensure that the tempered tortenite structure that meets the performance requirements is obtained. In addition, stress relief annealing and stabilization treatment are also processes that cannot be ignored in the manufacturing process of the substrate. The level of carbon content in steel has a great influence on the mechanical properties of the product. Because the role of the matrix is very important, high-strength steel must be selected, and through scientific and strict hot and cold processing, the matrix has the following goals and requirements:

1.After welding the first segment, it is not necessary to adjust the straightness again.

2. The segments on the base body can be fully utilized without the need for intermediate maintenance or saw blade inspection.

3. By reducing the thickness of the base body, the cost of the segment block is reduced, and the sawing resistance and cutting loss are reduced.

4. Lowest cost of leveling required after re-welding the segments.

5. Lots of reuse.


Send Inquiry
Contact Us
    •  Tel: +86-595-22030606

    •  Fax: +86-595-28681577

    •  Mobile/WhatsApp: +8613626067625

    •  QQ: 399611083

    •  Wechat: TOOLWITS

    •  E-mail: jay@toolwits.com

    •  Factory: Xipu Industrial Zone, Heshi Town, Luojiang District, Quanzhou City, Fujian Province, China 362022

    •  Office: Room 811, Fuxin Wealth Center, NO.55 Chenzhou Road, Fengze District, Quanzhou City, Fujian Province, China

    • facebook twitter linkedin instagramyoutubepinterest