In the actual use of diamond wire saw, especially in stone quarry, because of the transformation of cutting surface and the constant change of cutting position, there will be many remaining diamond wire saw with different lengths and different degrees of wear, and these diamond wire saw often has a certain service life. Therefore, they can be mixed together, continue to use, to ensure the maximum extension of diamond wire saw service life.
Diamond wire saw mixed use must comply with the following principles, that is, the same type, the same number of beads per meter, bead diameter difference within 0.1~0.2mm, wire diameter of the same diamond wire saw can be mixed use. On the contrary, diamond wire saw for electroplating, sintering diamond wire saw can not be mixed; Injection molding, spring, spring plus injection molding or rubber injection sealing type diamond wire saw can not be mixed; Open and uncut diamond wire saw, old and new diamond wire saw can not be mixed together.
This is because after mixing diamond wire saws with large diameter difference, beads with large diameter will be rapidly worn or even broken in a short time. The uncut diamond wire saw is connected to the wire saw that has been used together, because the rubber or plastic sealing layer of the new wire saw is not removed, the beads are not cut, the rubber or plastic sealing layer with great friction will encounter great resistance in the slit, it is easy to heat, the rubber wire saw may be broken, and the plastic softening phenomenon may occur in the injection wire saw. The beading compresses the plastic spacers and gathers them together, thus damaging the diamond wire saw.
The service life of diamond wire saw in operation depends on its technological process and the quality of metal powder and diamond. There is a trustworthy manufacturer in Quanzhou, China, TOOLWITS, which produces not only high quality diamond wire saw but also diamond wire saw machine for stone quarry, is the best customer’s choice target.
