Home > Knowledge > Content

Installation of wire saw machine for vertical sawing

Jul 06, 2022

Wire Saw Machine 55KW for marble

Whether the positional relationship between the saw machine and the cut surface is correct or not directly affects the quality of sawing. The positional relationship between the two is correct, and the roughness error of the sawing surface is small. When the ratio of the height to the width of the vertical surface is equal to 2:1, and the area is 100 square meters, the flatness error that can be achieved by the wire saw cutting surface can be controlled at Within 10cm, the minimum can reach 5cm; If the relative position between the two is incorrect, the sawed surface will be curved, spiral or twisted. Even if the area of the block shaping surface is less than 10 square meters, there may be a curved surface with a flatness error of 30 cm, and a large-area cutting surface The flatness error sometimes even reaches 1 meter. When this happens, it will not only affect the quality of blocks, reduce the rate of blocks, but also affect the consumption ofwire rope and the efficiency of sawing. Whether it is the separation and cutting of ore bodies, the decomposition and cutting of long blocks, or the shaping and cutting of blocks, it is first necessary to determine the position of the saw machine. The sawing machine is required to move within the vertical cutting working position and must not affect the operations of other mining processes around it. The working length of the wire saw guide rail is usually 9 meters. When starting sawing, the front end of the saw machine is at a minimum distance of 1 meter from the ore body or stone to be cut. The length of the working site for the saw machine should be at least 11 meters. When the step height is greater than 6 meters meters, this distance should be increased. If there are no special requirements, when sawing the vertical surface of the ore body, the cutting surface of the wire saw machine should be vertical to the front of the ore body. The work site of the wire saw machine can be located on the bottom or top of the mining step, but the bottom surface on which the wire saw machine is installed should be flat and solid.


Send Inquiry
Contact Us
    •  Tel: +86-595-22030606

    •  Fax: +86-595-28681577

    •  Mobile/WhatsApp: +8613626067625

    •  QQ: 399611083

    •  Wechat: TOOLWITS

    •  E-mail: jay@toolwits.com

    •  Factory: Xipu Industrial Zone, Heshi Town, Luojiang District, Quanzhou City, Fujian Province, China 362022

    •  Office: Room 811, Fuxin Wealth Center, NO.55 Chenzhou Road, Fengze District, Quanzhou City, Fujian Province, China

    • facebook twitter linkedin instagramyoutubepinterest