Because our wire saw has the advantages of flexible use, free cutting direction, and diverse cutting materials, this has led to the wire saw becoming a stone processing machine that stone manufacturers love to use. In addition, the wire saw has a long working time, so we say, One of our wire saws is basically working every day. However, because the wire saw is processing various brittle and hard materials for a long time every day, the wire saw is easily worn out, which will cause the cutting speed of the wire saw to drop. Then how do we restore the wire saw after a period of use? How about cutting speed? Since the wire saw is divided into cutting directions, we should pay attention to the cutting direction of the wire saw when using it. We must follow the arrow direction indicated on each clip of the wire saw. Do not cut in the opposite direction to avoid the front and rear ends of our beads. The taper ensures the normal use of the diamond beaded wire saw.
After the sintered diamond beaded wire saw is used for a period of time, if the cutting speed decreases, a certain number of refractory bricks can be neatly placed on the mineral material for sharpening. When the diamond bead wire saw is cutting, it must be cooled, otherwise it will burn the beads, and in severe cases, the entire diamond bead wire saw will be scrapped. We can generally use tap water to cool the wire saw, but we cannot use cooling water arbitrarily. The amount of cooling water is not as much as possible. The amount of cooling water used is specified. The amount of cooling water is 1.5 to 2 times the diameter of the diamond beaded wire saw. , The specific operation can be adjusted according to the noise during cutting and the turbidity of the cooling water. If the amount of cooling water is too much, it will easily affect the self-sharpening of the diamond bead wire saw and cause the wire saw to slip. Too little cooling water will easily cause the beads to heat up and affect the cutting life.
By paying attention to the above points, we can maintain the cutting speed of the wire saw.
